Repair Review Car

1. Lay a blanket down in the area where the hardtop will be stored. Put the other blanket nearby.
2. Open both doors on the 560SL. Find the latches in each of the four corners of the hardtop where it meets the body of the car. The latches are set into the top of the sides of the body and are flush to the surface when in the closed position. They look similar to hard, plastic, rounded rectangular plugs.
3. Open all four hardtop latches by fitting the tip of an index finger in the groove molded into the end of each latch and pulling up to release.
4. Pull up the seat back-release lever on the drivers seat, and push the seat back down toward the steering wheel.
5. Reach behind the drivers seat, and turn the crank handle of the rear latch counterclockwise until the latch releases. The rear of the hardtop will pop up away from the car body slightly when the rear latch releases.
6. Stand on one side of the vehicle, and have a helper stand on the other side. Lift the hardtop up off the body of the car. Walk toward the rear of the Mercedes together, carrying the hardtop. Once the hardtop is no longer over the car, carry it together to where the blanket is laid down and place it on the blanket.
7. Place the additional blanket over the hardtop to protect it while in storage.

1. Drive the BMW 740 into your garage or driveway because if you perform this removal procedure on the side of the road it will look like you are stealing the stereo. Place the 740 in Park and pull the emergency brake to make sure it does not shift while you are working on it. Make sure the car is off before you continue.
2. Pull the two plastic cup holders out from the center arm rest by hand. Unscrew the Philips head screws at the bottom of the cup holder holes. Go to the back seat of the 740 and pull the ash tray out from the rear of the front center arm rest. Unscrew the two Philips head screws that are underneath. Pull the center arm rest up and then back and place it to the side so that it does not get bent. Pull the emergency brake jacket off and the center plastic bezel from around the shifter.
3. Pry the bottom of the center console bezel up with a flat screwdriver. Be very gentle, as you can easily crack the plastic. Work the screwdriver in the seam between the center console bezel and the rest of the dash. Pull the center console bezel straight back and then up once all the pegs are disengaged. Place the center console somewhere safe, as it too is prone to cracking.

1. Open the trunk of the 300CE and disconnect the battery with a socket wrench. Remove only the negative terminal.
2. Open the drivers-side door and insert the removal key into the four holes around the climate control unit, making sure the flat side is facing outward when inserting the key. Twist the key to unlock each locking tab.
3. Pull the climate control unit out of the vehicle and disconnect its wiring harness at the rear of the unit. Installation is the reverse of removal.
4. Reconnect the negative battery terminal and close the trunk.

1. Engage the emergency brake. Open the armrest to reveal the inside of the center console storage compartment. Remove personal items from the storage compartment.
2. Remove the two screws connected to the armrest located on the inside of the storage compartment.
3. Remove the cover on the gearshift lever by removing the two screws located near the top of the cup holder compartment.
4. Remove the two screws on the inside of the storage compartment housing on the floor closest to the gear shift.
5. Disconnect the left and right rear window switches located on the rear wall inside the storage compartment. Disconnect the connector from the floor on the inside of the storage compartment.
6. Remove the four remaining screws from the inside of the storage compartment housing. The screws are located near the rear of the housing on the floor. Set the shift lever to neutral and remove the housing.